Mazda 6 Clutch Stuck To Floor

You could damage the clutch the clutch fork or the transmission.

Mazda 6 clutch stuck to floor. I got a new. Clutch pedal stays to the floor and car is now clutch hydralics is gone meaning you have a leak check clutch master cylinder see if its empty if so refill and pump pedal sevarel time may have to lift by hand sometimes then look for a leak most times it the slave cylinder thats what pushs clutch fork to disengage clutch. I went to pick and pull picked up a separate small clutch reservoir from some older car for 2 installed it nearby the brake clutch reservoir of my car and corked the existing clutch fluid outlet. So everywhere i looked it seemed that the slave cylinder was the culprit.

That was last week. It only happened here and there until finally it stuck to the floor and became very difficult if not impossible to get out of gear. Thus i separated the clutch and brake fluids started using a new mix for clutch and fixed the problem forever. Pedal stuck to floor while in traffic.

The clutch started sticking a couple weeks ago right where it would engage into gear and i d have to use my foot to pop it back up. I have a mazda 6 and when i press down on my clutch it goes to the floor and stays there. Answered by a verified auto mechanic. Also had corksport braided clutch line installed at same time.

Install was done by a trusted local mechanic and has been bled 3 times now to no avail. Part 1 of 4. Do not attempt to start the engine and drive the vehicle with the clutch pedal stuck all the way to the floor. Preparing the vehicle to check the clutch pedal for a failed release bearing.

Part 1 of. This has happened three times in the last 10 years. Pressed clutch in loud noise heard then grinding. At first it depressed to the floor and stuck.

Car i had happily owned 2 mazda 6 2006 sedan and wagon and was considering another when the diesel comes out. This week without warning the clutch pedal went to the floor and made a loud bang grinding noise. Hope this is helpful good luck. Then i pulled it back now it won t depress.

Check all the linkage to the pedal if it looks good you will need to pull the trans to check the clutch assembly and through out bearing and the sleeve it rides on. I have a 2006 mazda 6 with 104k on it. Car is a 2006 gg mazda 6 mps recently installed new dba 4000s slotted rotors and remsa pads and at the same time had a full brake clutch flush with nulon super dot 4. Today the clutch on my 6 speed mazda miata only has12 000 miles failed to engage and i was unable to get the car into gear.

You could damage the clutch the clutch fork or the transmission.